Set The Domain Id; Connect To The Fabric And Configure Fabric Parameters - HP StorageWorks 2/64 - Core Switch Installation Manual

Set the Domain ID

Each switch in the fabric must have a unique Domain ID. You can set the Domain ID using the
configure command. You can also allow the system to set the Domain ID automatically.
NOTE: The default Domain ID for the Core Switch 2/64
To set the Domain ID, follow these steps:
1. Enter the fabricShow command to determine the available Domain IDs.
2. Enter the switchDisable command to disable the Core Switch 2/64 or the SAN
Director 2/128.
3. Enter the configure command.
Enter y at the fabric parameters prompt:
4.
Fabric parameters (yes, y, no, n): [no] y
5. Enter a unique Domain ID:
Domain: (1..239) [1] 3
6. Complete the remaining prompts or press Ctrl+D to accept the other settings and exit.
7. Enter the switchEnable command to reenable the Core Switch 2/64 or the SAN
Director 2/128.

Connect to the fabric and configure fabric parameters

Before connecting the Core Switch 2/64 or the SAN Director 2/128 to the fabric, verify that
all the switches in the fabric use the correct port identifier (PID) settings. For information on
setting the PIDs, refer to the HP StorageWorks procedures user guide for the Fabric OS version
running on your switch.
To connect the switch to the fabric, follow these steps:
1. Add SFP transceivers and cables to the Fibre Channel ports, as required.
The ports are color-coded to indicate which ones can be used in the same trunking groups.
Four ports marked with solid black ovals alternate with four ports marked with oval outlines.
The ports and cables used in trunking groups must meet specific requirements. For a list of
these requirements, refer to the "ISL Trunking" section of the HP StorageWorks features
overview for the Fabric OS version running on your switch.
60 Installing and configuring the switch
SAN Director 2/128 is 1.
or the