Settings - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data
I f you click on a slot , addit ional cart ridge inform at ion will be shown
in a pop up window. This inform at ion includes t he cart ridge
barcode ( if label and barcode reader is inst alled) and t he error
code.
5.2.4 Settings Pages
On t he set t ing
configurat ion. These pages can only be accessed by som eone who
is logged in as Administrator.
Personalization
On t his page you can change t he Rem ot e Managem ent passwords.
To secure your syst em , change bot h t he passwords t he first t im e
you use the system. It is possible to clear the remote management
passwords via
Maintenance Menus.
Here you m ay also t urn on em ail event not ificat ion. When event
not ificat ion is enabled, t he St orageLoader will send warnings and
errors by email to the recipient's e- mail address.
Network
On t his page it is possible t o change t he I P configurat ion. See
det ails in chapt er
configuration will take effect at next system reset.
Warning: Please verify t hat t he chosen set t ings are correct and
consistent before resetting the loader. Any mistakes will have to be
corrected via the front panel.
SCSI-ID
On this page it is possible to change the SCSI- ID on your drive and
loader. See details in section 4.4.2, SCSI Setup.
Cleaning Options
By defining a cleaning slot , t he St orageLoader will regard t he
cartidge in this slot as the cleaning cartridge unless:
1. anot her cart ridge has previously been report ed t o be a
cleaning cartridge by the drive, or
2. t he loader cont ains a cart ridge wit h a bar code label
indicating that it is a cleaning cartridge.
StorageLoader Installation and User Manual
pages, you can
t he front panel,
Rem ot e Managem ent
change t he St orageLoader
please see sect ion
set up.
Maintenance
0 The
The new
53