Tandberg Data STORAGELOADER Installation And User Manual page 17

Tandberg Data
- 2 Line Power Cords: one for USA/ Japan and one for
European power outlets
- 1 VHDCI SCSI Interface Cable
- 1 68- pin VHDCI LVD/SE SCSI Terminator.
- 1 Ethernet cable
- Tool for Emergency Magazine Release
- 30 StorageLoader specific Bar code labels
There will be variat ions of t his list . Please also refer t o your Quick
I nstallation guide shipped with the StorageLoader.
Note: The StorageLoader contains no cartridges before shipment.
Step 2. Installing the StorageLoader in a Rack
The StorageLoader is designed for use in 19" rack system using 1U
of rack space. The lengt h of t he power cord and t he SCSI cable
may restrict the placement.
Attention: The St orageLoader is designed t o operat e in a
horizont al posit ion. Do not at t em pt t o operat e t he St orageLoader
in any other position than horizontally. Also make sure that:
The airflow around t he front and back of t he St orageLoader
is not obstructed.
There is a minimum of 60cm free space in front of the unit to
allow the operator to safely remove the magazines.
The display and operator controls are easily accessed.
The St orageLoader is away from t he floor , and in a clean
environm ent
Appendix A.
The Rack Mounting Kit includes the following items:
Rail Left Assembly
Rail Right Assembly
Screw M6x12 (6 pieces)
Screw M5x8 (2 pieces)
Recommended mounting tools:
StorageLoader Installation and User Manual
wit h t em perat ure wit hin
Operation and Configuration
specificat ion, see
15