Figure 3.8 Main Power Switch, Fuse Holder And Power Cord Connection - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data
Step 3. Connecting Power Cable
The StorageLoader is offered both with AC and DC connection.
- DC connection.
This version is offered wit h special connect or and - 48 VDC voltage.
This is described
requirements and special connector.
AC connection
Before connect ing t he St orageLoader t o your host com put er
syst em you should run t he self- diagnost ic of t he unit . This
preparat ion requires power t o t he St orageLoader. Go t hrough t he
following steps to perform this test:
1. Use t he power cables from t he accessories included in t he
shipm ent . Make sure you select t he power cord suit ed for
your power system.
2. Plug t he power cable int o t he rear of t he St orageLoader ( see
figure 3.8) . Plug t he ot her end of t he cable int o a properly
grounded electrical outlet.
Note: Reliable eart hing depends on eart hing in t he AC elect rical
out let , in which t he St orageLoader's power cable is connect ed.
Adding the StorageLoader to an existing rack installation can cause
a leaking current fault condit ion because of t he sum m at ion of t he
leaking current s. For securit y, a 250V 2A ( H) fuse is locat ed near
the power switch.
3. Turn on the StorageLoader
by swit ching
Swit ch
I f t he t ransport
present t he
det ect t his and inst ruct
t he user t o rem ove it , see
next step.
20
in appendix. A2. Please not e grounding
t he Power
t o " 1" .
lock is
loader will
Figure 3.8 Main Power switch, fuse
holder and power cord connection
StorageLoader Installation and User Manual
Operation and Configuration