Tandberg Data STORAGELOADER Installation And User Manual page 85

Tandberg Data
1209 Failed to fetch at
slot 09
2000 Drive not found
2001 Drive hardware
fault detected.
StorageLoader Installation and User Manual
Failed to eject 1. Reboot the loader and retry the
cartridge from operation.
drive 2. Try to eject the cartridge from
the drive via the front panel menu.
3.Remove the drive FRU. Connect
power to drive and push the
drive's eject button. If this fails,
remove cartidge by following the
drive's emergency eject
procedure.
Communication 1. Reboot the loader and retry the
error between operation.
the loader and 2. Remove back-panel cover plate
the drive. and check the SCSI cabling and
the ADI cabling.
The drive has Reboot the loader and retry the
reported a operation. If the problem persists
hardware fault. replace the drive.
Maintenance
Defect drive or
robotics. Defect
cartridge.
SCSI and signal
cables, power
cables; defective
power supply;
defective drive.
Defective drive
83