Figure 3.9 Robotics Lock Marked With Red Plastic Tab - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data
Step 4. Removing the Transport Lock
The robot m echanism
is prot ect ed
dam age during
shipm ent wit h
screw holding
robot ics in a locked
position.
This locking screw is
m arked wit h a red
plast ic t ab prot ruding
bet ween t he
m agazine and
front panel assembly.
This locking screw
must be removed
before
StorageLoader can
operate normally.
The locking screw will be det ect ed when t he St orageLoader is
powered on. The display will show a message indicating the locking
screw has been det ect ed. The display will inst ruct t he user t o
rem ove t he m agazine t o gain access t o t he locking screw. Rem ove
t he screw and reinsert t he m agazine. The loader will now continue
its power on sequence, see next step.
For manual/emergency release of the magazine, see section 4.8.5.
Note: Keep t he screw in a safe place. You will need it t o lock t he
robot if you need t o ret urn your St orageLoader t o t he supplier for
service or repair.
Important: The warrant y does not cover dam age t o t he loader,
shipped wit hout t he locking screw properly inst alled. See sect ion
6.4, Reinstalling the Transport Lock , on how t o re- inst all t he
transport lock.
Step 5. Running Power-On Selftest
Aft er t he t ransport lock is rem oved, t he loader will cont inue
running it 's power- on selft est and doing an invent ory of it s
cartridges.
The word I dle and t he cart ridge m ap will appear on t he default
display screen. I f t he self- diagnost ics and t he invent ory sequence
are successfully com plet ed, t he green LED will illum inat e. The
StorageLoader is now ready to be installed in the system.
StorageLoader Installation and User Manual
from
a
t he
right
t he

Figure 3.9 Robotics lock marked with red plastic tab

the
Operation and Configuration
21