Figure 3.10 Scsi Cable And Scsi Terminator Connection - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data
D) Before t he St orageLoader is powered on and t he syst em is
rest art ed,
t erm inat ed. I f t he St orageLoader t erm inat es t he SCSI bus, it
is recom m ended
accessory kit box on t he lower SCSI connect or on t he back
plane. See figure 3.10.
To connect the SCSI bus cable:
1. On t he rear
connect or of t he SCSI cable t o t he upper SCSI connect or,
see figure 3.10.
2. Secure the cable with the thumbscrews on the connector.
3. Connect t he ot her end of t he SCSI cable t o t he appropriat e
SCSI adapt er on your syst em
thumbscrews.
4. I f t he St orageLoader is t he last device on t he SCSI bus,
inst all a SCSI bus t erm inat or t o t he free SCSI connect or on
t he St orageLoader. Make sure t hat t he t erm inat or is of t he
correct type for your SCSI system.
5. It is possible to daisy chain several SCSI devices on the SCSI
bus. I f you do, t he t erm inat or m ust be connect ed t o t he last
device on t he bus. Not e t hat t here are lim it at ions t o t he
SCSI cable length.

Figure 3.10 SCSI cable and SCSI terminator connection

Step 8. Connecting the Ethernet Connector
To connect t he St orageLoader t o t he Et hernet , use t he provided
cable from the accessory kit box.
1. I nsert one end of t he cable int o t he St orageLoader Et hernet
port . Push unt il it snaps int o place. The open port in figure
3.10 is for Ethernet connection.
StorageLoader Installation and User Manual
m ake sure t hat
t o connect
of t he St orageLoader, at t ach t he device
Operation and Configuration
t he SCSI bus
t he t erm inat or
and fast en it wit h t he
is properly
from t he
23