Figure 3.5 Slide The Storageloader In From The Front - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data
Slide t he St orageLoader on t he rails from t he front of t he rack, as
shown in figure 3.5. Then fix t he St orageLoader using one M6x12
screw in front of t he rack on bot h left and right side ( see figure
3.6) and one M5x8 on t he backside of t he Rack Mount ing Kit on
both left and right side (see figure 3.7).
Figure 3.5 Slide the StorageLoader in
from the front
Figure 3.7 Fasten the rear of the StorageLoader to the rails.
How to dismount the StorageLoader from the rack
Make sure t hat you have disconnect ed all t he cables before you
start dismounting the StorageLoader from the rack.
Unscrew t he M5x8 screws at t he back of t he rack m ount ing kit .
(See figure 3.7)
Unscrew t he M6x12 screw at t he front of t he rack. Not e t hat you
only unscrew the lowest screw. (See figures 3.5 and 3.6)
Slide t he St orageLoader gent ly out of t he rack. Not e t hat t he
StorageLoader's weight is 14.6kg!
StorageLoader Installation and User Manual
Figure 3.6 Fasten the front of the
StorageLoader to the rack
Use one M5x8 screw on both left
and right side (M5-thread) to
fasten the StorageLoader to the
rails' backside.
Operation and Configuration
19