Manual/Emergency Release Of Magazines; Standby Functionality; Figure 4.21 Pointing Out Hole Used To Insert Release Tool; Figure 4.22 Magazine Release Tool In Use - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data

4.8.5 Manual/Emergency Release of Magazines

I n case of failure sit uat ions eit her in t he loader it self, a power loss,
or if you want t o m anually release t he m agazines for som e ot her
reason, a m anual/ em ergency release is available. To act ivat e t he
em ergency m agazine feat ure, you m ust use t he special m agazine
release t ool which is part of t he accessory kit shipped t oget her
wit h t he St orageLoader. This t ool m ust be ent ered t hrough t he
hole marked in figure 4.21.
Note: The m anual ej ect m ust only be used when power is t urned
off.
Ent er t he release
t ool in hole four from

Figure 4.21 Pointing out hole used to insert release tool

Figure 4.22 shows the
release t ool insert ed
int o t he correct hole
on the right hand side
magazine bezel.

4.9 Standby Functionality

On the front panel a standby button is available.
To act ivat e St andby m ode, press t he but t on for a m inim um of 2
second, t he St orageLoader will t hen ent er a st andby m ode in a
cont rolled m anner.
StorageLoader goes into standby mode.
46

Figure 4.22 Magazine release tool in use

The following
StorageLoader Installation and User Manual
Operation and Configuration
t akes place before t he