Fru Power Supply; Figure 6.11 Exchanging A Defective Power Supply; Figure 6.12 Removing The Fixing Screw - Tandberg Data STORAGELOADER Installation And User Manual

Tandberg Data
drive and the brackets laying on a level surface to ensure the
brackets are aligned with the bottom of the drive. Fasten the
brackets with two screws each.
Insert the replacement drive carefully into the loader the same way
it was removed, reconnect the 3 cables (the ADI cable is mounted
closest towards the SCSI cable) and re- mount the back plate.
Snap t he front bezel t hat was rem oved from t he replacement- drive
ont o t he front of t he defect ive drive. Then pack t he defect ive drive
in t he sam e box you received t he replacem ent - drive and ret urn it
to your support center.

6.5.3 FRU Power Supply

This FRU consists of the following parts:
S808696 Power Supply FRU StorageLoader 1U
Item Description
1 Power supply
2 Quick Installation Guide Fan
To exchange a defective power-supply switch off the loader and
disconnect the power cord. Dismounting the backpanel cover plate by
removing these two screws:

Figure 6.11 Exchanging a defective power supply

Figure 6.12 Removing the fixing screw

Rem ove t he fixing screw ( Figure 6.12) . Wit hdraw t he power-
StorageLoader Installation and User Manual
Maintenance
Removing the fixing screw
Qty
1
1
65