Processor Dc Specifications; Absolute Maximum Ratings - Intel CELERON 1.10 GHZ Datasheet

® ®
Intel Celeron Processor up to 1.10 GHz
Table 4.

Absolute Maximum Ratings

Symbol
T
STORAGE
V (All)
CC
VinAGTL+
VinCMOS
I
VID
I
SLOTOCC
I
CPUPRES
Mech Max
Edge Fingers
NOTES:
1. Operating voltage is the voltage to which the component is designed to operate. See
2. This rating applies to the V
3. Parameter applies to CMOS, APIC, and TAP bus signal groups only.
4. The electrical and mechanical integrity of the processor edge fingers are specified to last for 50 insertion/
extraction cycles.
5. S.E.P. Package Only
6. PGA Packages Only
7. Input voltage can never exceed V
8. Input voltage can never go below V
9. Parameter applies to CMOS (except BCLK, PICCLK, and PWRGOOD), APIC, and TAP bus signal groups
only for VinCMOS on the FC-PGA/FC-PGA2 Packages only.
10.Parameter applies to CMOS signals BCLK, PICCLK, and PWRGOOD for VinCMOS1.5 on FC-PGA/
FC-PGA2 Package only.
2.10

Processor DC Specifications

The processor DC specifications in this section are defined for the Celeron processor. See
Section 7.0
Most of the signals on the Intel Celeron processor system bus are in the AGTL+ signal group.
These signals are specified to be terminated to 1.5 V. The DC specifications for these signals are
listed in Table
To allow connection with other devices, the Clock, CMOS, APIC, and TAP signals are designed to
interface at non-AGTL+ levels. The DC specifications for these pins are listed in
Table 5 through
Intel Celeron processor system bus frequencies. Specifications are valid only while meeting
specifications for case temperature, clock frequency, and input voltages. Care should be taken to
read all notes associated with each parameter.
24
Parameter
Processor storage temperature
Any processor supply voltage with
respect to V
SS
• PPGA and S.E.P.P.
• FC-PGA/FC-PGA2
AGTL+ buffer DC input voltage with
respect to V
SS
• PPGA and S.E.P.P.
• FC-PGA/FC-PGA2
CMOS buffer DC input voltage with
respect to V
SS
• PPGA and S.E.P.P.
• FC-PGA/FC-PGA2
Max VID pin current
# Max SLOTOCC# pin current
# Max CPUPRES# pin current
Mechanical integrity of processor
5
edge fingers
, V
CC CORE
SS
TT
for signal definitions and
6.
Table 8 list the DC specifications for Intel Celeron processors operating at 66 MHz
Min
–40
–0.5
–0.5
–0.3
V - 2.18
TT
-0.3
V - 2.18
TT
-0.58
, and any input (except as noted below) to the processor.
CC 5
+ 2.8 volts.
- 2.18 volts.
Section 5.0 for signal listings.
Max Unit
85 °C
Operating
V
voltage + 1.0
2.1 V
V + 0.7 V
CC CORE
2.18 V
3.3 V
2.18 V
3.18 V
5 mA
5 mA
5 mA
Insertions/
50
Extractions
Table 5.
Table 7.
Datasheet
Notes
1, 2
7, 8
3
7, 8, 9
10
5
6
4, 5