Processor Dc Specifications; Voltage And Current Specifications For The Dual-Core, Extreme Edition Processors - Intel P8700 - Core 2 Duo Processor Datasheet

2. Excessive overshoot or undershoot on any signal will likely result in permanent damage to
the processor.
3. Storage temperature is applicable to storage conditions only. In this scenario, the
processor must not receive a clock, and no lands can be connected to a voltage bias.
Storage within these limits will not affect the long-term reliability of the device. For
functional operation, please refer to the processor case temperature specifications.
4. This rating applies to the processor and does not include any tray or packaging.
5. Failure to adhere to this specification can affect the long-term reliability of the processor.
6. For Intel® Core™2 Duo mobile processors in 22x22 mm package.
3.10

Processor DC Specifications

The processor DC specifications in this section are defined at the processor
core (pads) unless noted otherwise.
The tables list the DC specifications for the processor and are valid only while meeting
specifications for junction temperature, clock frequency, and input voltages. The
Highest Frequency Mode (HFM) and Lowest Frequency Mode (LFM) refer to the highest
and lowest core operating frequencies supported on the processor. Active mode load
line specifications apply in all states except in the Deep Sleep and Deeper Sleep states.
V
CC,BOOT
set the VID values. Unless specified otherwise, all specifications for the processor are at
T = 105 °C. Read all notes associated with each parameter.
J
Table 6. Voltage and Current Specifications for the Dual-Core, Extreme Edition
Processors (Sheet 1 of 2)
Symbol
V in Enhanced Intel® Dynamic Acceleration
CC
V
CCDAM
Technology Mode
V V at Highest Frequency Mode (HFM)
CCHFM CC
V V at Lowest Frequency Mode (LFM)
CCLFM CC
V at Super Low Frequency Mode
CC
V
CCSLFM
(Super LFM)
V Default V
CC,BOOT CC
V AGTL+ Termination Voltage
CCP
V PLL Supply Voltage
CCA
V V at Deeper Sleep
CCDPRSLP CC
V V at Intel® Enhanced Deeper Sleep State
DC4 CC
V at Deep Power Down Technology State
CC
V
CCDPPWDN
(C6)
I for Processors Recommended Design
CC
I
CCDES
Target
I for Processors
CC
Processor
Number
I
CC
X9100
32
is the default voltage driven by the voltage regulator at power up in order to
Parameter
Voltage for Initial Power Up
Core Frequency/Voltage
3.06 GHz & V
CCHFM
1.6 GHz & V
CCLFM
0.8 GHz & V
CCSLFM
Electrical Specifications
Min Typ Max
1.0 1.325
1.0 — 1.275
0.85 — 1.1
0.8 — 1.0
— 1.20
1.00 1.05 1.10
1.425 1.5 1.575
0.65 — 0.85
0.6 — 0.85
0.35 — 0.7
— — 60
— — —
— — —
59
— — 34
24
Unit Notes
V 1, 2
V 1, 2
V 1, 2
V 1, 2
V 2, 6
V
V
V 1, 2
V 1, 2
V
A 12
A 3, 4, 10
Datasheet