Bootable Cd-Rom Is Not Detected; Error And Informational Messages; Post Codes And Countdown Codes; Standard Bios Port-80 Codes - Intel SRKA4 - Server Platform - 0 MB RAM Product Manual

Verify that the baseboard jumpers are set correctly. See the SKA4 Baseboard Product Guide
for more information.
If other software runs correctly on the system, contact your vendor about the failing software.
If the problem persists, contact the software vendor's customer service representative for
assistance.

Bootable CD-ROM Is Not Detected

Check the following:
Is the BIOS set to allow the CD-ROM to be the first bootable device?

Error and Informational Messages

When you turn on the system, POST displays messages that provide information about the system.
If a failure occurs, POST emits beep codes that indicate errors in hardware, software, or firmware.
If POST can display a message on the video display screen, it causes the speaker to beep twice as
the message appears.

POST Codes and Countdown Codes

Table 5.

Standard BIOS Port-80 Codes

CP Beeps
Xx 1-1-1-1
16 1-2-2-3
20 1-3-1-1
22 1-3-1-3
28 1-3-3-1
2C 1-3-4-1
46 2-1-2-3
58 2-2-3-1
98 1-2
B4 1
Table 6.

Recovery BIOS Port-80 Codes

CP Beeps
Xx 1-1-1-1
Solving Problems
Reason
There are no processors present in the system, or the processors are so
incompatible that the system BIOS cannot be run (like mismatched cache voltages)
BIOS ROM checksum
Test DRAM refresh
Test 8742 Keyboard Controller
Autosize DRAM, system BIOS stops execution here if the BIOS does not detect
any usable memory DIMMs
Base RAM failure, BIOS stops execution here if entire memory is bad
Check ROM copyright notice
Test for unexpected interrupts
Search for option ROMs. One long, two short beeps on checksum failure
One short beep before boot
Reason
There are no processors present in the system, or the processors are so
incompatible that the system BIOS cannot be run (like mismatched cache voltages).
77