Installing The Hard Drive Bay; Removing The Hard Drive Bay From The Chassis - Intel SRKA4 - Server Platform - 0 MB RAM Product Manual

7. With a flat head screwdriver, pry the right side of the hard drive bay out of the chassis.
Figure 33. Removing the Hard Drive Bay From the Chassis
8. Install the fan board assembly. See "Installing a Fan Board Assembly" on page 63.
9. Install the top cover. See "Installing the Top Cover" on page 51.
10. Install the front cover. See "Installing the Front Cover" on page 51.

Installing the Hard Drive Bay

1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the front cover. See "Removing the Front Cover" on page 50.
3. Remove the fan board assembly. See "Removing a Fan Board Assembly" on page 62.
4. Slide the hard drive bay into the chassis until the tabs engage the slots on the chassis.
5. Connect the cables to the hard drive bay. There are four of them.
6. Install the SCSI hard drives. See "Installing a SCSI Hard Drive" on page 28.
7. Install peripheral devices. See "Installing a Drive in the Configurable Media Bay" on page 68.
8. Install the fan board assembly. See "Installing a Fan Board Assembly" on page 63.
9. Install the top cover. See "Installing the Top Cover" on page 51.
10. Install the front cover. See "Installing the Front Cover" on page 51.
Removing and Installing System Components
OM09959
67