Intel SRKA4 - Server Platform - 0 MB RAM Product Manual page 32

12. If you are installing a full-length board, lock the Rear Retention Latch. See Figure 12 on
page 29.
13. Use the screw removed earlier to fasten the new board to the chassis. Tighten the screw firmly
(6.0 inch-pounds).
14. Attach cables if necessary.
15. Power on the add-in board through the PCI Hot-plug application on your system or through the
HW push-button.
16. Check that no left loose tools or parts were left inside the system.
17. Position the top cover over the chassis so that the rows of tabs align with slots in the chassis.
Slide the cover toward the front of the system until the tabs on the cover firmly engage in the
chassis.
18. Attach the top cover to the chassis with the two thumbscrews released earlier, and tighten them
firmly.
19. Connect any external cables.
32 SRKA4/ISP4400 Server System Product Guide