Setting The Time To Standby Mode - Fujitsu 6010N - fi - Document Scanner Operator's Manual

4.6.6 Setting the Time to Standby Mode

The scanner can be set to automatically log out and then enter a standby state after specified peri-
ods of non-use.
For any screen after regular user login, if no operations have been performed for the specified
"Logout after" period of time, the scanner automatically logs the user out.
HINT
When logged in as a regular user, if no operations are performed for the specified "Standby after"
period of time, the scanner enters standby mode. The touch panel is switched off when the scanner
enters standby mode.
When the startup button is pressed, the scanners will startup from standby mode.
The screen displayed after a re-startup varies according automatic login settings in the following
way:
If automatic login is enabled, the operation screen is displayed.
However, if "Never" is specified for "Standby after", and automatic login is disabled for
the currently logged in user, the login screen is displayed.
If automatic login is disabled, the login screen in displayed.
For screen transmissions, refer to
66
The scanner will not logout while the following operations are ongoing:
Scanning documents
e-Mailing a scan
Faxing a scan
Printing a scan
Saving a scan
"2.2.1 Using the Startup Button" (page 26).