Setting The Time To Standby Mode - Fujitsu ScanSnap N1800 Operator's Manual

4.7.2 Setting the Time to Standby Mode

The scanner can be set to automatically log out and then enter a standby state after
specified periods of non-use.
For any window after regular user login, if no operations have been performed for the
specified [Logout after] period of time, the scanner automatically logs the user out.
The scanner does not logout while the following operations are ongoing:
In the [Login] window or the window which is shown after the scanner is logged in by a
regular user, if no operations are performed for the specified [Standby after] period of
time, the scanner enters standby mode. the LCD touch panel is switched off when the
scanner enters standby mode.
When the power button is pressed, the scanners start up from standby mode.
The window displayed after a re-startup varies according automatic login settings in the
following way:
If automatic login is enabled, the operation window is displayed.
If automatic login is disabled, the login window in displayed.
For window transitions, refer to
1. Select [System Settings]
The [Standby Mode] window appears.
Scanning documents
e-Mailing a scan
Faxing a scan
Printing a scan
Saving a scan
Automatic login is enabled
"Using the Power Button" (page
[Login Settings]
107
Central Admin
Console
59).
[Standby Mode].