Fujitsu 6010N - fi - Document Scanner Operator's Manual page 225

Press the [Name Format] button to specify a file name on the "File Names
HINT (Common)" screen.
"Sub-folders" is enabled only when scanned data is saved to a folder.
For details about setting values, refer to
for When Saving Scanned Data" (page
Check the Scan Count
When the number of sheets to be scanned for a job is fixed, set whether to check that the
expected amount of sheets has been scanned.
If [Yes] is selected
The number of scanned sheets is checked while a job is being processed.
For "Expected Count", enter the expected number of sheets to be scanned, between
1 and 999.
ATTENTION
Select the [Allow per-Job adjustment] checkbox to make it possible to change the
expected count of sheets to be scanned on the "Scan Count" screen, according to
each job.
Select the [Confirm the Scan Count] checkbox to have the actual and expected
sheet counts displayed on the "Scan Count" screen after scanning is complete.
If [No] is selected
The number of scanned sheets is not checked while a job is being processed.
72).
If a "Print" job item is included, the expected number of
sheets to be scanned becomes 1 to 100.
For "Print", up to 100 pages can be scanned. For other than
"Print", up to 999 pages can be scanned. For duplex scan-
ning, make sure to set the number of pages so as not to
exceed these respective maximums.
fi-6010N Network Scanner Operator's Guide
4.11 Setting Job Features
"4.6.9 Setting a File Name Format
4
187