Setting The Ntp Server - Fujitsu 6010N - fi - Document Scanner Operator's Manual

4.7.6 Setting the NTP Server

1. Select the [Network Settings] tab on the top menu.
2. Select the [NTP Server] tab on the left side menu.
The "NTP Server" screen appears.
For Central Admin Console, can only set the NTP server address.
3. Enter the NTP server IP address, host name, or FQDN in the "Address" input field.
For an IP address
The following format should be used xxx.xxx.xxx.xxx (xxx is a value from 0 to
255).
For a host name or FQDN
Up to 255 characters may be entered.
If an NTP server is not required, leave this field blank.
4. Press the [Sync Time] button.
The result of the time synchronization for the specified NTP server is shown.
If no error message appears, the NTP server setting is valid.
If an error message appears, refer to
5. Press the [OK] button on the confirmation message screen.
96
"E.1.1 Administrator Screen Messages" (page 503).