Fujitsu 6010N - fi - Document Scanner Operator's Manual page 242

3. Enter the job menu name.
This may be up to 64 characters long.
4. Select the job button position, and select the [Edit] button.
The "Job Button Settings" window appears.
5. Enter the job button name.
This may be up to 32 characters long.
6. In the [Select Button Pixmap] drop-down list box, select a job button pixmap.
The selected job button pixmap is inserted into the job button mockup image on the right,
allowing the resulting button design to be checked.
7. Set whether to start up the Add-in module.
To start up the Add-in module when the job button is selected, select the [Use button to start
Add-in module] checkbox.
If this checkbox is selected, the Add-in module is assigned to the job button, rather than the
job sequence. The "Job Button Name" and "Select Button Pixmap" are ignored. The button
specified by the Add-in module appears in the Job Menu.
ATTENTION
204
Even if the checkbox is selected, if the Add-in module is not installed in
a scanner, the target job menu button will not be shown on the screen.