Setting The Wait Time In Power Saving Mode [Power Saving] - Fujitsu fi-6670 Operator's Manual

Chapter 8 Operational Settings
Setting the Wait Time in Power Saving Mode
[Power saving]
This scanner switches to power saving mode automatically to
save power when it remains unused for a certain period of
time.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (on page
134).
2
From the tree listing on the left, select [Device Setting].
3
Use the slide control bar to set the waiting time before
entering into power saving mode.
You can specify the waiting time in the range of 15 to 55 minutes (in
increments of 5 minutes).
When you select the [Power off after a certain period of
time] check box, the scanner will turn itself off automati-
cally if it is turned on and left unused for the set time.
The time until power-off can be selected from 1/2/4/8
hours.
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
166