Chapter 8 Operational Settings
Setting the Waiting Time to Enter Power Saving
Mode [Power saving]
When the scanner is not being used for a certain period of
time, it enters power saving mode to save the power
consumption.
1
Start up the Software Operation Panel.
Refer to
"8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting].
3
Use the slide bar to specify the waiting time to enter
power saving mode.
It can be set in the range of 5 to 235 minutes (in increments of
5 minutes).
When you select the [Power off after a certain period of
time] check box, the scanner will turn itself off
automatically if it is turned on and left unused for the set
time. The time until power-off can be selected from 1/2/4/
8 hours.
132).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
178