Monitoring The Redundancy History Of Line Modules In A Specific Slot - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual

Software for e series broadband services routers service availability configuration guide
Table of Contents

Advertisement

Table 16: show redundancy line-card slot slotNum Output Fields (continued)
Field Name
met
Clients with Unsafe
Configurations for High
Availability
client
mode
configuration
Related
Documentation

Monitoring the Redundancy History of Line Modules in a Specific Slot

Purpose
Action
host1#show redundancy history line-card slot 3
system
up
slot
time
----
--------
3
00:32:09
2009-06-10 17:56:15
host1#show redundancy history line-card slot 3 detail
Copyright © 2010, Juniper Networks, Inc.
Field Description
Whether the criterion for high availability of the line-module pair is satisfied. Possible values:
Yes—The specific criterion has been met for the system to enter the active state
No—The specific criterion has not been met and the system transitions to the pending
state
Whether the client supports high availability and also the safety level of configuration
Name of the application that is running on the line module configured for high availability
High availability status of the application running on the line module: supported or
unsupported
Safety level of the configuration based on whether or not the client is supported or
unsupported and in case of those unsupported, whether or not the client has been configured.
For example, if an unsupported client has been configured on a router with high availability
enabled, the configuration reads "unsafe"
Activating High Availability on page 88
Deactivating High Availability on page 89
mode
line-card switch
show redundancy history
show redundancy line-card
Display information about dates, times, and the number of occurrences for starts and
switchovers for a line module installed in a particular slot.
To display information about the number of occurrences for starts and switchovers for
a particular line module:
last
last
cold
warm
switchover
switchover
---------
-------
2009-06-01 17:56:15
To display additional redundancy history information:
Chapter 4: Managing Stateful Line Module Switchover
Number
of cold
switchovers
------
8
Number
of
warm
switchovers
-------
2
97

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents