Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual page 54

JunosE 11.3.x Service Availability Configuration Guide
32
Table 7: show redundancy Output Fields (continued)
Field Name
Criteria Preventing High
Availability from being Active
Criteria Required for High
Availability to be Active
Line Card
automatic reverting
slots
hardware role
lockout config
backed up by slot
sparing for slot
revert at
midplane type
midplane rev
fabric slice redundancy
slot
slice state
type
Field Description
Criteria preventing the router from being in the active
state of high availability mode.
NOTE: For the router to be in the Active state, all
criteria for this option must be "yes".
Criteria required for the router to be in the active state
of high availability mode.
NOTE: For the router to be in the Active state, all
criteria for this option must be "yes".
State of automatic reverting. Possible states: on or
off.
Slots in which the line modules reside.
Function of the line module. Possible values: primary
or spare.
Status of redundancy on the line module:
protected—Line module redundancy is enabled
locked out—Line module redundancy is disabled
Slot that contains the line module that is a spare for
this primary line module.
Slot that contains the primary line module for which
this module is a spare.
Time at which you want the line module to revert.
Identifier for the type of midplane.
Hardware revision number of the redundancy
midplane.
Status of the fabric slice on the SRP modules or SFMs
on the E120 and E320 routers.
Slot in which the fabric slice resides.
State of the fabric slice. Possible values: online or not
present.
Identifier for the type of hardware. Possible values:
SRP modules or SFM modules.
Copyright © 2010, Juniper Networks, Inc.