Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual page 66

JunosE 11.3.x Service Availability Configuration Guide
44
Table 8: Application Support for Stateful SRP Switchover (continued)
Application Supported
IP
IPv6
IPv6 neighbor
discovery
IPSec Transport –
IPSec Tunnels
IS-IS
IS-ISv6
OSPFv2
OSPFv3
RIP
Static Routes (IP
and IPv6)
Telnet
IPv4 Multicast
Routing
Unsupported Notes
– –
– –
– IPv6 neighbor discovery characteristics
are replayed during switchover. Line
modules do not flush neighbor discovery
information during the switchover.
–
– Completed IKE phase 1 and phase 2
negotiations supported only.
– Supported only when the graceful restart
extension is enabled.
– Supported only when the graceful restart
extension is enabled.
– Supported only when the graceful restart
extension is enabled.
– Supported only when the graceful restart
extension is enabled.
– Static recovery support only.
– After all high-priority interfaces have
been replayed from NVS and mirrored
storage, static routes are replayed from
NVS, followed by replay of low-priority
interfaces from NVS and mirrored
storage. This behavior enables static
routes that are dependent on
high-priority interfaces to be resolved
quickly and installed in the IP routing
table.
– Static recovery support only.
Copyright © 2010, Juniper Networks, Inc.