Monitoring The Redundancy Status Of Srp Modules; Table 12: Show Redundancy Line-Card Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual

Related
Documentation

Monitoring the Redundancy Status of SRP Modules

Purpose
Action
Copyright © 2010, Juniper Networks, Inc.

Table 12: show redundancy line-card Output Fields

Field Name
automatic reverting
slots
hardware role
lockout config
backed up by slot
sparing for slot
revert at
midplane type
midplane rev
show redundancy line-card
Display redundancy information specific to SRP modules.
To display the redundancy status of the SRP modules.
host1#show redundancy srp
high-availability state:
current redundancy mode:
last activation type:
To display the redundancy status of the SRP modules in detail.
host1#show redundancy srp detail
high-availability state:
current redundancy mode:
last activation type:
Criteria Required for High Availability to be Active
----------------------------------------------------
criterion
----------------------------------------------------
Active SRP hardware supports High Availability?
Chapter 3: Managing Stateful SRP Switchover
Field Description
State of automatic reverting (on or off).
Slots in which the line modules reside.
Function of the line module: primary or spare.
Status of redundancy on this line module:
protected—Line module redundancy is enabled
locked out—Line module redundancy is disabled
Slot that contains the line module that is a spare for
this primary line module.
Slot that contains the primary line module for which
this line module is a spare.
Time at which you want line module to revert.
Identifier for the type of midplane.
Hardware revision number of the redundancy
midplane.
active
high-availability
warm-switch
disabled
file-system-synchronization
cold-start
met
---
Yes
63