Table of Contents
Advertisement
JunosE 11.3.x Service Availability Configuration Guide
Related
Documentation
Configuring the Interface on Which the ICR Partition Resides
176
Configure the interface.
1.
See "Configuring the Interface on Which the ICR Partition Resides" on page 176.
Create a unique VRRP instance to manage the ICR partition.
2.
See "Configuring VRRP Instances to Match ICR Requirements" on page 177.
Create and assign a name to the ICR partition.
3.
See "Naming ICR Partitions" on page 178.
(Optional) Select the grouping criterion for the ICR partition.
4.
See "Grouping ICR Subscribers Based on S-VLAN IDs" on page 178 and "Grouping ICR
Subscribers Based on VLAN IDs" on page 179.
NOTE: Grouping subscribers based on S-VLAN IDs is the default grouping
option for ICR partitions. If you do not explicitly specify the grouping option,
subscribers are grouped based on S-VLAN IDs.
(Optional) Configure RADIUS.
5.
See "Using RADIUS to Manage Subscribers Logging In to ICR Partitions" on page 182.
ICR Overview on page 169
Monitoring the Configuration of ICR Partitions on page 184
Monitoring the Configuration of an ICR Partition Attached to an Interface on page 183
Monitoring the Status of ICR Partition Accounting
You can create multiple ICR partitions on an interface. For information on the number of
ICR partitions that you can create, see JunosE Release Notes, Appendix A, System
Maximums.
To configure the interface on which the ICR partition resides:
Specify a FastEthernet, GigabitEthernet, or 10–GigabitEthernet interface.
1.
host1(config)#interface gigabitEthernet 3/5/0
host1(config-if)#
Specify VLAN as the encapsulation method to create the VLAN major interface.
2.
host1(config-if)#encapsulation vlan
Create a VLAN subinterface by adding a subinterface number to the interface
3.
identification number.
host1(config-if)#interface gigabitEthernet 3/5/0.10
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
