Table 7: Show Redundancy Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual

Meaning
Copyright © 2010, Juniper Networks, Inc.
---- -------- ---------
0 spare ---
2 primary protected
4 primary protected
fabric slice redundancy : none
slot state type
------ -------- --------
6 online SFM-100
7 online SFM-100
8 --- ---
9 --- ---
10 --- ---
Table 7 on page 31 lists the show redundancy command output fields.

Table 7: show redundancy Output Fields

Field Name
SRP
high-availability state
current redundancy mode
last activation type
Chapter 2: Managing Module Redundancy
------ ------- ------
--- --- ---
--- --- ---
--- --- ---
Field Description
State of high availability mode:
disabled—Initial, default state for high-availability
mode. The router continues to use file system
synchronization.
active—Data synchronized from the active SRP
module to the standby SRP module during
initialization remains synchronized through
mirroring updates.
pending—If an unsupported application is
configured, the router transitions to this state.
initializing—If SRP module is in initializing state,
bulk synchronization of memory and NVS occurs.
Redundancy mode currently used by the router:
high-availability—Ensures rapid SRP module
recovery after a switchover by using initial bulk file
transfer and subsequent, transaction-based
mirroring.
file-system-synchronization—Default redundancy
mode of the router. SRP modules reload all line
modules and restart form saved configuration files.
Last type of activation that occurred on the router.
The method using which the SRP last booted:
cold-start—When the router is in pending state and
switchover occurs, the router undergoes a
cold-start or cold switch.
warm-start—When the router is in active state and
switchover occurs, the router undergoes a warm
switch or
warm-start.
31