Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual page 48

JunosE 11.3.x Service Availability Configuration Guide
26
Table 5: show environment Output Fields (continued)
Field Name
timing
system operational
slot
type
temperature
processor temperature
processor temperature status
IOA temperature
IOA temperature status
processor temperature ranges
Field Description
Source of the timing signal:
primary—Type and status of the primary timing
signal
secondary—Type and status of the secondary
timing signal
tertiary—Type and status of the tertiary timing
signal
auto-upgrade—Status of the auto-upgrade
parameter, which enables the system to revert to
a higher-priority timing source after switching to a
lower-priority timing source.
Status of the system
Number of the slot in which the module resides
Type of module in the slot on the E120 and E320
routers
Temperature of the line module, SRP module, or SFM
on the E120 and E320 routers
Temperature of the line module or SRP module
Temperature condition of the line module:
normal—Temperature is within the normal range
too hot—Module is too hot; system will go into
thermal protection mode if the temperature of any
module exceeds 80 C
too cold—Module is too cold; system will go into
thermal protection mode if the temperature of any
module drops below -5 C
Temperature of the corresponding I/O module or IOA
Temperature condition of the corresponding I/O
module or IOA:
normal—Temperature is within the normal range
too hot—Module is too hot; system will go into
thermal protection mode if the temperature of any
module exceeds 80 C
too cold—Module is too cold; system will go into
thermal protection mode if the temperature of any
module drops below -5 C
Temperature ranges for the line modules and SRP
modules.
Copyright © 2010, Juniper Networks, Inc.