Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual page 213

forwarding events
on egress queues
not preserving across stateful switchover
of LMs....................................................................72
forwarding rates
on egress queues
not preserving across stateful switchover
of LMs....................................................................72
H
hardware
monitoring information................................................23
high availability
activating...................................................................20, 52
activating guidelines......................................................51
deactivating......................................................................53
IP interface priority........................................................54
overview.............................................................................35
high availability mode
redundancy mode..........................................................37
high availability mode, line modules
brief pause in data forwarding
when secondary module becomes
primary..................................................................83
initial bulk transfer of data
to newly assigned primary module................83
no impact on existing user sessions.......................83
synchronization of state and dynamic
configuration
between primary and secondary LMs...........83
transaction-based mirroring subsequently
to newly assigned primary module................83
high availability pair
of line modules
unified ISSU disabled on the
secondary..............................................................71
unified ISSU support on the primary...............71
high availability, line module See stateful line
module switchover
high availability, line modules
activating
launching Redundancy Configuration
mode.....................................................................88
specifying slots of primary and secondary
modules...............................................................88
activating guidelines.....................................................87
deactivating.....................................................................89
deactivating guidelines...............................................89
Copyright © 2010, Juniper Networks, Inc.
error message displayed
when maximum limit is exceeded for pairs
configured...........................................................88
maximum pairs that can be configured................88
I
icr cluster...................................................................................172
ICR commands
interface ..........................................................................176
icr interface...............................................................................172
ICR Options
icr-control-interface.....................................................177
priority command..........................................................177
timers-learn command...............................................177
ICR Partition
configuring ....................................175, 176, 177, 178, 179
configuring, naming.....................................................178
radius.................................................................................182
ICR partition accounting
and dependence on Acct-Stop messages..........175
configuring.......................................................................173
disabling and enabling messages
sent to the RADIUS server................................173
overview............................................................................173
processing in different scenarios
administrative switchover.................................175
complete chassis failure....................................175
line module or interface failure.......................175
transition of ICR partition states....................175
ICR Partition commands
naming .............................................................................178
ICR partition ID VSA
including in access and accounting
messages.....................................................................174
ICR Partition ID VSA
transmitting to the virtual router
where ICR control interface is
configured...........................................................174
where ICR partition is configured...................174
ICR Partition Options
advertise-mac......................................................179, 180
control-interface .................................................179, 180
group option..........................................................178, 180
use-default-mac ................................................179, 180
Index
191