Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual page 80

JunosE 11.3.x Service Availability Configuration Guide
58
Table 9: show redundancy Output Fields (continued)
Field Name
last activation type
Criteria Preventing High
Availability from being Active
Criteria Required for High
Availability to be Active
Line Card
automatic reverting
slots
hardware role
lockout config
backed up by slot
sparing for slot
revert at
midplane type
midplane rev
Field Description
Last type of activation that occurred on the router.
The method using which the SRP last booted:
cold-switch—When the router is in pending state
and switchover occurs, the router undergoes a
cold-switch or cold re-start.
warm-switch—When the router is in active state
and switchover occurs, the router undergoes a
warm-switch or warm re-start.
Criteria preventing the router from being in the active
state of high availability mode.
NOTE: For the router to be in the Active state, all
criteria for this option must be "yes".
Criteria required for the router to be in the active state
of high availability mode.
NOTE: For the router to be in the Active state, all
criteria for this option must be "yes".
State of automatic reverting. Possible states: on or
off.
Slots in which the line modules reside.
Function of the line module. Possible values: primary
or spare.
Status of redundancy on the line module:
protected—Line module redundancy is enabled
locked out—Line module redundancy is disabled
Slot that contains the line module that is a spare for
this primary line module.
Slot that contains the primary line module for which
this module is a spare.
Time at which you want the line module to revert.
Identifier for the type of midplane.
Hardware revision number of the redundancy
midplane.
Copyright © 2010, Juniper Networks, Inc.