Ce-Series Card Pos Ports Utilization Window; Ce-Series Card Pos Ports History Window; Performance Monitoring For Optical Cards - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

15.7 Performance Monitoring for Optical Cards

Table 15-22
Parameter
gfpStatsCSFRaised
ifInPayloadCrcErrors
ifOutPayloadCrcErrors
hdlcPktDrops
1. Applicable only for CE100T-8, CE-MR-10
2. Applicable only for CE1000-4

15.6.4.5 CE-Series Card POS Ports Utilization Window

The POS Ports Utilization window shows the percentage of Tx and Rx line bandwidth used by the POS
ports during consecutive time segments. The Utilization window provides an Interval drop-down list that
enables you to set time intervals of 1 minute, 15 minutes, 1 hour, and 1 day. Line utilization is calculated
with the following formulas:
Rx = (inOctets * 8) / (interval * maxBaseRate)
Tx = (outOctets * 8) / (interval * maxBaseRate)
The interval is defined in seconds. The maxBaseRate is defined by raw bits per second in one direction
for the Ethernet port (that is, 1 Gbps). The maxBaseRate for CE-Series cards is shown in
page
Line utilization numbers express the average of ingress and egress traffic as a percentage of capacity.
Note

15.6.4.6 CE-Series Card POS Ports History Window

The Ethernet POS Ports History window lists past Ethernet POS ports statistics for the previous time
intervals. Depending on the selected time interval, the History window displays the statistics for each
port for the number of previous time intervals as shown in
parameters are defined in
15.7 Performance Monitoring for Optical Cards
This section lists PM parameters for ONS 15454 optical cards, including the OC-3, OC-12, OC-48, and
OC-192 cards.
Cisco ONS 15454 Reference Manual, R8.5
15-48
CE-Series Card POS Ports Parameters (continued)
Definition
Number of GFP Client signal fail frames detected at the GFP-T receiver.
1
Received payload CRC errors.
1
Transmitted payload CRC errors.
Number of received packets dropped before input.
15-31.
Table 15-22 on page
Figure 15-20 shows the signal types that support near-end and far-end PMs.
Chapter 15
Table 15-15 on page
15-47.
Performance Monitoring
Table 15-14 on
15-31. The listed
78-18106-01