Ml-Series Card Ether Ports History Window; Ml-Series Pos Ports Window; Ml-Series Pos Ports Parameters For Hdlc Mode - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

Chapter 15 Performance Monitoring

15.6.3.3 ML-Series Card Ether Ports History Window

The Ethernet Ether Ports History window lists past Ethernet statistics for the previous time intervals.
Depending on the selected time interval, the History window displays the statistics for each port for the
number of previous time intervals as shown in
defined in

15.6.3.4 ML-Series POS Ports Window

In the ML-Series POS Ports window, the parameters displayed depend on the framing mode employed
by the ML-Series card. The two framing modes for the POS port on the ML-Series card are HDLC and
frame-mapped generic framing procedure (GFP-F). For more information on provisioning a framing
mode, refer to Cisco ONS 15454 Procedure Guide.
Table 15-18
ML-Series Ethernet card POS Ports GFP-F parameters.
Table 15-18
Parameter
ifInOctets
rxTotalPkts
ifOutOctets
tx TotalPkts
etherStatsDropEvents
rxPktsDropped Internal
Congestion
mediaIndStatsRxFrames
Truncated
mediaIndStatsRxFrames
TooLong
mediaIndStatsRxFrames
BadCRC
mediaIndStatsRxShort
Pkts
hdlcInOctets
hdlcRxAborts
hdlcOutOctets
78-18106-01
Table 15-17 on page 15-34.
defines the ML-Series Ethernet card POS Ports HDLC parameters.

ML-Series POS Ports Parameters for HDLC Mode

Definition
Number of bytes received since the last counter reset.
Number of packets received.
Number of bytes transmitted since the last counter reset.
Number of transmitted packets.
Number of received frames dropped at the port level.
Number of received packets dropped due to overflow in frame buffer.
Number of received frames with a length of 36 bytes or less.
Number of received frames that are too long. The maximum is the
programmed maximum frame size (for VSAN support); if the maximum
frame size is set to default, then the maximum is the 2112 byte payload plus
the 36 byte header, which is a total of 2148 bytes.
Number of received frames with CRC errors.
Number of received packets that are too small.
Number of bytes received (from the SONET/SDH path) prior to the bytes
undergoing HLDC decapsulation by the policy engine.
Number of received packets aborted on input.
Number of bytes transmitted (to the SONET/SDH path) after the bytes
undergoing HLDC encapsulation by the policy engine.
15.6.3 ML-Series Ethernet Card Performance Monitoring Parameters
Table 15-15 on page 15-31. The listed parameters are
Cisco ONS 15454 Reference Manual, R8.5
Table 15-19 defines the
15-37