Provisioning Osi In Ctc; Osi Actions From The Ctc Provisioning Tab; Osi Actions From The Ctc Maintenance Tab - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

Chapter 13 Management Network Connectivity

13.6.10 Provisioning OSI in CTC

Table 13-15
Cisco ONS 15454 Procedure Guide for OSI procedures and tasks.
Table 13-15
Tab
OSI > Main Setup
OSI > TARP > Config
OSI > TARP > Static TDC
OSI > TARP > MAT
OSI > Routers > Setup
OSI > Routers > Subnets
OSI > Tunnels
Comm Channels > SDCC
Comm Channels > LDCC
Table 13-16
Table 13-16
Tab
OSI > ISIS RIB
OSI > ESIS RIB
OSI > TDC
78-18106-01
shows the OSI actions that are performed from the node view Provisioning tab. Refer to the

OSI Actions from the CTC Provisioning Tab

Actions
• View and edit Primary Area Address.
• Change OSI routing mode.
• Change LSP buffers.
Configure the TARP parameters:
PDU L1/L2 propagation and origination.
•
TARP data cache and loop detection buffer.
•
LAN storm suppression.
•
Type 4 PDU on startup.
•
TARP timers: LDB, T1, T2, T3, T4.
•
Add and delete static TARP data cache entries.
Add and delete static manual area table entries.
Enable and disable routers.
•
Add, delete, and edit manual area addresses.
•
Edit SDCC, LDCC, and LAN subnets that are provisioned for OSI.
Add, delete, and edit Cisco and IP-over-CLNS tunnels.
• Add OSI configuration to an SDCC.
Choose the data link layer protocol, PPP or LAP-D.
•
Add OSI configuration to an SDCC.
•
shows the OSI actions that are performed from the node view Maintenance tab.

OSI Actions from the CTC Maintenance Tab

Actions
View the IS-IS routing table.
View ESs that are attached to ISs.
View the TARP data cache and identify static and dynamic entries.
•
• Perform TID to NSAP resolutions.
Flush the TDC.
•
13.6.10 Provisioning OSI in CTC
Cisco ONS 15454 Reference Manual, R8.5
13-61