Tl1 Craft Interface Installation; Cards And Slots; Table 1-30 Lan Pin Assignments; Table 1-31 Craft Interface Pin Assignments - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

Chapter 1 Shelf and Backplane Hardware
Table 1-30
Pin Field
LAN 1
Connecting to data circuit-terminating
equipment (DCE
LAN 1
Connecting to data terminal equipment
(DTE) (a PC/workstation or router)
1. The Cisco ONS 15454 is DCE.

1.16.4 TL1 Craft Interface Installation

You can use the craft pins on the ONS 15454 backplane or the EIA/TIA-232 port on the TCC2/TCC2P
card faceplate to create a VT100 emulation window to serve as a TL1 craft interface to the ONS 15454.
Use a straight-through cable to connect to the EIA/TIA-232 port.
for the CRAFT pin field.
You cannot use the craft backplane pins and the EIA/TIA-232 port on the TCC2/TCC2P card
Note
simultaneously.
To use the serial port craft interface wire-wrap pins on the backplane, the DTR signal line on the
Note
backplane port wire-wrap pin must be connected and active.
Table 1-31
Pin Field
Craft

1.17 Cards and Slots

ONS 15454 cards have electrical plugs at the back that plug into electrical connectors on the shelf-
assembly backplane. When the ejectors are fully closed, the card plugs into the assembly backplane.
Figure 1-44
78-18106-01
LAN Pin Assignments
1
, a hub or switch)
Craft Interface Pin Assignments
Contact
A1
A2
A3
A4
shows card installation.
Backplane Pins RJ-45 Pins
B2 1
A2 2
B1 3
A1 6
B1 1
A1 2
B2 3
A2 6
Table 1-31
Function
Receive
Transmit
Ground
DTR
Cisco ONS 15454 Reference Manual, R8.5
1.16.4 TL1 Craft Interface Installation
shows the pin assignments
1-71