Table of Contents
Advertisement
Chapter 8
Cisco Transport Controller Operation
Table 8-6
Port Color
Green
Violet
Figure 8-4
Figure 8-5
8.6.1.2 Node View Card Shortcuts
If you move your mouse over cards in the graphic, popups display additional information about the card
including the card type; the card status (active or standby); the type of alarm, such as Critical, Major, or
Minor (if any); and the alarm profile used by the card. Right-click a card to reveal a shortcut menu, which
you can use to open, reset, delete, or change a card. Right-click a slot to preprovision a card (that is,
provision a slot before installing the card).
8.6.1.3 Node View Tabs
Table 8-7
Table 8-7
Tab
Alarms
Conditions
78-18106-01
Node View Card Port Colors and Service States (continued)
Service State
IS-NR
OOS-AU,AINS
Terminal Loopback Indicator
Facility Loopback Indicator
lists the tabs and subtabs available in the node view.
Node View Tabs and Subtabs
Description
Lists current alarms (CR, MJ, MN) for the node
and updates them in real time.
Displays a list of standing conditions on the
node.
Description
(In-Service and Normal) The port is fully operational and
performing as provisioned. The port transmits a signal and
displays alarms; loopbacks are not allowed.
(Out-of-Service and Autonomous, Automatic In-Service)
The port is out-of-service, but traffic is carried. Alarm
reporting is suppressed. The node monitors the ports for an
error-free signal. After an error-free signal is detected, the
port stays in OOS-AU,AINS state for the duration of the
soak period. After the soak period ends, the port service
state changes to IS-NR.
Raised fault conditions, whether or not their alarms are
reported, can be retrieved on the CTC Conditions tab or by
using the TL1 RTRV-COND command. The AINS port will
automatically transition to IS-NR when a signal is received
for the length of time provisioned in the soak field.
Subtabs
—
—
Cisco ONS 15454 Reference Manual, R8.5
8.6.1 Node View
8-11
Advertisement
Table of Contents
