Table 5-12 G1K-4 Port-Level Indicators; Ml100T-12 Card; Figure - Cisco 15454-DS1-14= - 1.544Mbps Expansion Module Reference Manual

5.6.4 G1K-4 Port-Level Indicators
5.6.4 G1K-4 Port-Level Indicators
The G1K-4 card has four bicolor LEDs (one LED per port).
color represents.
Table 5-12
Port-Level LED Status
Off
Steady amber
Solid green
Flashing green

5.7 ML100T-12 Card

For hardware specifications, see the
Note
The ML100T-12 card provides 12 ports of IEEE 802.3-compliant, 10/100 interfaces. Each interface
supports full-duplex operation for a maximum bandwidth of 200 Mbps per port and 2.488 Gbps per card.
Each port independently detects the speed of an attached device (autosenses) and automatically connects
at the appropriate speed. The ports autoconfigure to operate at either half or full duplex and can
determine whether to enable or disable flow control. For ML-Series configuration information, see the
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration
Guide.

Figure 5-6

Caution Shielded twisted-pair cabling should be used for inter-building applications.
Cisco ONS 15454 Reference Manual, R8.5
5-16
G1K-4 Port-Level Indicators
Description
No link exists to the Ethernet port.
A link exists to the Ethernet port, but traffic flow is inhibited. For example,
a lack of circuit setup, an error on the line, or a nonenabled port might inhibit
traffic flow.
A link exists to the Ethernet port, but no traffic is carried on the port.
A link exists to the Ethernet port, and traffic is carried on the port. The LED
flash rate reflects the traffic rate for the port.
"A.7.9 ML100T-12 Card Specifications" section on page
shows the card faceplate and block diagram.
Chapter 5
Table 5-12 describes the status that each
Ethernet Cards
A-51.
78-18106-01