Table of Contents
Advertisement
16.7.2 Variable Trap Bindings
16.7.2 Variable Trap Bindings
Each SNMP trap contains variable bindings that are used to create the MIB tables. ONS 15454 traps and
variable bindings are listed in
are associated with all of its variable bindings.
Table 16-8
Supported ONS 15454 SNMPv2 Trap Variable Bindings
Trap Name(s) Associated
Group
with
A
dsx1LineStatusChange
(from RFC 2495)
B
dsx3LineStatusChange
(from RFC 2496)
Cisco ONS 15454 Reference Manual, R8.5
16-10
Table 16-8.
Variable
Binding
Number
SNMPv2 Variable Bindings
(1)
dsx1LineStatus
(2)
dsx1LineStatusLastChange
(3)
cerent454NodeTime
(4)
cerent454AlarmState
(5)
snmpTrapAddress
(1)
dsx3LineStatus
(2)
dsx3LineStatusLastChange
(3)
cerent454NodeTime
For each group (such as Group A), all traps within the group
Description
This variable indicates the line
status of the interface. It contains
loopback, failure, received alarm
and transmitted alarm
information.
The value of MIB II's sysUpTime
object at the time this DS1
entered its current line status
state. If the current state was
entered prior to the last
proxy-agent reinitialization, the
value of this object is zero.
The time that an event occurred.
The alarm severity and
service-affecting status.
Severities are Minor, Major, and
Critical. Service-affecting
statuses are Service-Affecting
and Non-Service Affecting.
The address of the SNMP trap.
This variable indicates the line
status of the interface. It contains
loopback state information and
failure state information.
The value of MIB II's sysUpTime
object at the time this DS3/E3
entered its current line status
state. If the current state was
entered prior to the last
reinitialization of the
proxy-agent, then the value is
zero.
The time that an event occurred.
Chapter 16
SNMP
78-18106-01
Advertisement
Table of Contents
