C Documentation Updates; March 30, 2010: Sp3 (10.3); Chapter 2, "Coexistence With Other Zenworks Products," On - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual

Documentation Updates
C
This section contains information on documentation content changes that were made in this
Installation Guide for Novell
can help you to keep current on updates to the documentation.
The documentation is provided on the Web in two formats: HTML and PDF. The HTML and PDF
documentation are both kept up-to-date with the documentation changes listed in this section.
If you need to know whether a copy of the PDF documentation you are using is the most recent, the
PDF document contains its publish date on the front title page.
The documentation was updated on the following date:
Section C.1, "March 30, 2010: SP3 (10.3)," on page 87
C.1 March 30, 2010: SP3 (10.3)
Updates were made to the following sections:
Location
Section 1.1, "Primary Server Requirements," on
page 9
Section 1.3, "Management Zone Version
Requirements," on page 17
Section 1.6, "Managed Device Requirements," on
page 21
Section 1.7, "Inventoried-Only Device
Requirements," on page 25
Chapter 2, "Coexistence with Other ZENworks
Products," on page 29
Section 3.3.5, "Installing Mono 2.0.1-1.17 on SLES
11," on page 46
"Mono (Only for SLES 11)" on page 11
® ®
ZENworks 10 Configuration Management SP3. The information
Update
Port 443 is now used for CASA authentication.
Windows Server 2008 R2 is now supported.
Updated this section.
Updated the section with Windows Server 2008 R2
and Windows 7 as additionally supported managed
device requirements.
Added the following information for a managed
device:
Updated the section with Windows 7 as an
additionally supported inventoried-only device
requirement.
Added information about ZENworks 10 coexistence
with other ZENworks products.
Updated this section to provide information on
installing Mono 2.0.1-1.17 on SUSE
Enterprise Server (SLES) 11.
Updated this section with the recommended Mono
version and RPM packages.
A managed device name must not exceed 32
characters. If a device name exceeds 32
characters, that device is not inventoried. In
addition, make sure that the device name is
unique so that the device is recognized
appropriately in the inventory reports.
C
®
Linux
®
Documentation Updates 87