Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual page 16

Item
Hostname Resolution
IP Address
TCP Ports
UDP Ports
16 ZENworks 10 Configuration Management Installation Guide
Requirements
The server must resolve device
hostnames by using a method such
as DNS (recommended).
Server names must support DNS
requirements, such as not having
underscores in their names, or
ZENworks login fails. Acceptable
characters are the letters a-z
(uppercase and lowercase),
numbers, and the hyphen (-).
If you use DNS, it must be properly
set up, or some features in
ZENworks might not work.
The server must have a static IP
address or a permanently leased
DHCP address.
An IP address must be bound to all
NICs on your target server.
80
998
7628
8005
8009
67
69
997
Additional Details
The agent installation hangs if it is
trying to use a NIC that does not
have an IP address bound to it
80 is for Tomcat non-secure port.
If the server is running other
services on ports 80 and 443, such
as Apache, or are used by OES2,
the installation program asks you
for new ports to use. However, you
must make sure that the new port is
same as the HTTP port used by the
parent Primary Server.
Used by Preboot Server.
Used by the Adaptive Agent.
Used by Tomcat to listen to
shutdown requests. This is a local
port, and cannot be accessed
remotely.
Used by Tomcat AJP connector.
Used by proxy DHCP when it is not
running on the same device as the
DHCP server.
Used by the Imaging TFTP, but will
not work across firewall because it
opens random UDP port for each
PXE device.
Used by the Imaging Server for
multicasting.