Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual page 77

The ZENworks uninstallation program perform the following actions:
Removes all the Satellite roles from the device.
Removes the entry for the device from ZENworks Control Center (Configuration tab >
Server Hierarchy panel).
11 Ensure that the Satellite roles have been removed from the device by running the
command.
12 (Conditional) If you want to uninstall the agent and unregister the device from the zone,
continue with "Uninstalling the ZENworks Adaptive Agent and Unregistering the Device from
the Zone" on page 77.
Uninstalling the ZENworks Adaptive Agent and Unregistering the Device from the
Zone
After demoting a Linux Satellite and removing the Satellite roles from it, perform the following
steps to remove the device from the Management Zone and uninstall the ZENworks Adaptive
Agent.
1 At the Linux Satellite console prompt, relaunch the uninstallation program by entering
novell/zenworks/bin/uninstall
2 Choose the locale (language) in which you prefer to run the uninstallation program by entering
the locale number.
To select the default locale (English), enter
TIP: Pressing Enter at any prompt causes the uninstallation program to accept the default,
which is the value shown in parentheses.
3 Read the introductory text, then press Enter.
4 On the Uninstallation Type screen, select the Unregister and Uninstall From Zone option by
pressing Enter.
5 On the ZENworks Management Zone Information screen, enter the IP address of the Primary
Server to which the Linux Satellite is registered.
6 Enter the port number on which the Primary Server is listening.
To select the default port 443, press Enter.
7 Enter the username of the zone administrator.
To use the default username (Administrator), press Enter.
8 Enter the zone administrator's password.
9 Review the summary, then press Enter to begin the uninstallation.
ZENworks uninstallation program performs the following actions:
Uninstalls ZENworks Adaptive Agent.
Removes all the RPMs related to ZENworks 10 Configuration Management SP3 from the
device.
Removes the device object from ZENworks Control Center (Devices tab > Managed tab >
Servers folder).
.
or press Enter.
2
zac satr
/opt/
Uninstalling ZENworks Software 77