Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual page 40

Ensure that the user schema has the following rights to create the database.
CREATE SESSION
CREATE_TABLE
CREATE_VIEW
CREATE_PROCEDURE
CREATE_SEQUENCE
CREATE_TRIGGER
IMPORTANT: For Oracle databases, performance can be affected by whether you configure
your database to use shared server or dedicated server processes. Each ZENworks Primary
Server is configured with a database connection pool whose size fluctuates with the ZENworks
system load. This pool can grow at peak loads to a maximum of 100 concurrent database
connections per Primary Server. If your Oracle database is configured to use dedicated server
processes, it is possible that your database server resource usage can reach undesirable levels
that affect performance when there are multiple Primary Servers in your zone. If you encounter
this problem, consider changing your ZENworks database to use shared server processes.
Performing the External ZENworks Database Installation
1 Make sure that the server where you plan to install the external database fulfills the
requirements in
Installing External Databases" on page
2 Start the database installation program.
2a On the server where you want to install the external database, insert the Novell ZENworks
10 Configuration Management SP3 installation DVD.
If the DVD autoruns the database installation program, exit the program.
If the server is Windows, continue with
2b For Windows, enter the following at the command prompt on the external database server:
DVD_drive:\setup.exe -c
or
If ZENworks 10 Configuration Management has already been installed on a device, and if
you want to use the device to configure another instance of the ZENworks database (on
the same device or on another device) by using the external database installation program,
run the following command:
DVD_drive:\setup.exe -c --zcminstall
2c For Linux, run the following command on the external database server:
sh /media/cdrom/setup.sh -c
This provides additional options that you do not have when installing the Primary Server,
especially if you want to make your OEM database a remote database. You can view the
SQL files generating the ZENworks database, create access users, view creation
commands (OEM Sybase only), and so on.
or
40 ZENworks 10 Configuration Management Installation Guide
Section 1.4, "Database Requirements," on page 20
38.
and
Step 2b. If the server is Linux, skip to
"Prerequisites for
Step 2c.