Linux Device Performing Satellite Roles - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual

Item Requirements
4011
13331

1.2.2 Linux Device Performing Satellite Roles

Currently, ZENworks Configuration Management lets you manage Windows devices only.
However, you can use an unmanaged Linux device to perform satellite roles.
The Linux device performing satellite roles must meet the following requirements:
Linux Device Performing Satellite Roles Requirements
Table 1-3
Item Requirements
Operating System:
Servers
Operating System:
Workstations
Hardware
Additional Details
Used for proxy DHCP when it is running on the same
device as the DHCP server. Make sure that the firewall is
configured to allow the broadcast traffic to the proxy
DHCP service.
Used by the zmgpreboot policy, but will not work across
firewall because it opens random UDP port for each PXE
device.
SLES 10 SP1 / SP2 / SP3 x86, x86-
64 (Intel and AMD Opteron*
processors)
OES 2 SP1 / SP2 x86, x86-64
SLES 11 x86, x86-64 (Intel and
AMD Opteron processors)
SUSE Linux Enterprise Desktop 10
(SLED 10) SP1 / SP2 x86, x86-64
SLED 11 x86, x86-64
Processor: Minimum - Pentium* IV
2.8 GHz 32-bit (x86) and 64-bit
(x86-64), or equivalent AMD or Intel
processor
RAM: 512 MB minimum; 2 GB
recommended
Disk Space: 128 MB minimum for
installing; 4 GB recommended for
running. Depending on the amount
of content you need to distribute,
this number can vary greatly.
Display resolution: 1024 × 768
with 256 colors minimum
Additional Details
System Requirements 15