Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual page 13

Item Requirements
5750
5950
7628
8005
8009
Firewall Settings: 67
UDP Ports
69
997
1761
4011
13331
Virtual Machine ZENworks Configuration Management
Environments server software can be installed in the
following virtual machine
environments:
VMware Workstations
Microsoft Virtual Server
XEN (Novell SLES 10 and Citrix
XenServer)
VMWare ESX
Windows 2008 Hyper Visor
NOTE: If a Primary Server is behind a NAT firewall, the devices on the Internet or public network
cannot communicate with it.
Additional Details
Used by Remote Management proxy.
Used by Remote Management service by
default. You can change this port in the
Remote Management Settings panel of the
Remote Management Configuration page in
ZENworks Control Center.
Used by the Adaptive Agent.
Used by Tomcat to listen to shutdown
requests. This is a local port, and cannot be
accessed remotely.
Used by Tomcat AJP connector.
Used by proxy DHCP when it is not running
on the same device as the DHCP server.
Used by the Imaging TFTP, but will not work
across firewall because it opens random
UDP port for each PXE device.
Used by the Imaging Server for
multicasting.
Port 1761 on the router is used to forward
subnet-oriented broadcast magic packets
for Wake-On-LAN.
Used for proxy DHCP when it is running on
the same device as the DHCP server. Make
sure that the firewall is configured to allow
the broadcast traffic to the proxy DHCP
service.
Used by the zmgpreboot policy, but will not
work across firewall because it opens
random UDP port for each PXE device.
When using a SLES 10 32-bit guest OS on
VMware ESX 3.5, do not use the VMI
kernel. For more information, see TID
7002789 in the Novell Support
Knowledgebase (http://support.novell.com/
search/kb_index.jsp).
System Requirements 13