Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual page 56

Installation
Information
License key for
Patch
Management
Pre-installation
summary
56 ZENworks 10 Configuration Management Installation Guide
Explanation
The ZENworks 10 Patch Management SP3 software is automatically installed.
However, the product is activated for patch downloads only if the following conditions
are met:
ZENworks 10 Configuration Management SP3 is active either in the licensed or
evaluation mode.
A patch subscription license key is specified, which you must purchase
independently. For more information, see
Subscription License" in the
Administration Quick
You can activate the subscription service later through the ZENworks Control Center.
For more information, see
Configuration Management System Administration
If you specify the license key, you must additionally specify the company name and
the e-mail address.
If you do not want to install ZENworks 10 Patch Management SP3, manually deselect
the Activate check box and do not specify the license key for the product. The product
is automatically installed; however, it is deactivated.
GUI Installation: To make changes to any information entered up to this point, click
Previous. After you click Install, the installation of the files begins. During installation,
you can click Cancel to stop, which leaves the files on your server that were installed
up to that point.
Command Line Installation: If you want to make changes to any information
entered up to this point, you can type
necessary. As you progress forward through the commands again, press Enter to
accept the decisions that you previously made.
"Purchasing and Activating a
ZENworks 10 Configuration Management
Start.
"ZENworks 10 Product Licensing" in the
Reference.
back and press Enter as many times as
ZENworks 10