Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual page 68

You can run the commands locally on the device by using the zac command line utility. If the agent
was installed on the Linux device by using an xsession or ssh session, you need to run zac by
entering the command . However, after logging in again, you
/opt/novell/zenworks/bin/zac
can run zac directly from the command line without typing the full path.
Package Options
You can use the options listed below when launching a deployment package from the command line.
The syntax is:
package name option1 option2 ...
For example:
SatelliteServer.bin -k regkey1
-d target_path: Extracts the files to the specified target path. The default target path is
.
c:\opt\novell\zenworks\stage
-h: Displays help information.
-k: The registration key used to register the device in the management zone.
-l: Lists the contents of the package only. Does not extract the package and run the installation.
-n: Extracts the package but does not run the installation.
-v: Turns on verbose screen logging.
In addition to the options listed above, there are two additional BUILDTIME options (-f file and -o
output_file) that are used when building packages. These options should only be used under the
direction of Novell Support.
68 ZENworks 10 Configuration Management Installation Guide