Installing Mono 2.0.1-1.17 On Sles 11 - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - INSTALLATION 10.3 Installation Manual

3.3.5 Installing Mono 2.0.1-1.17 on SLES 11

If your SLES 11 device on which you want to install ZENworks 10 Configuration Management SP3
does not have Mono installed, do the following to install Mono 2.0.1-1.17:
1 Start the ZENworks 10 Configuration Management SP3 installation program by using one of
the following methods:.
Graphical User Interface (GUI) installation: Mount the Novell ZENworks 10
Configuration Management SP3 installation DVD, then run
setup.sh
Command Line installation: Do the following:
2 Install Mono bundled with ZENworks 10 Configuration Management.
3 (Optional) The ZENworks 10 Configuration Management installation program allows you to
continue to install ZENworks 10 Configuration Management SP3. For more information on
how to install ZENworks, see
46 ZENworks 10 Configuration Management Installation Guide
. Using the command resolves rights issues.
sh
1. On the installation server, insert the Novell ZENworks 10 Configuration Management
SP3 installation DVD.
2. Mount the DVD.
3. To start a command line installation, do the following:
a. To a directory where all (including "others") have read and execute access,
either mount the DVD or copy the DVD's files.
This cannot be in
If you copy the DVD's files, make sure that all (including "others") continue to
have read and execute access to the destination directories.
b. Run the following command:
sh /mount_location/setup.sh -e
Section 4.1, "Performing the Installation," on page
or any directory under it.
/root
sh /media/cdrom/
47.