Turning On/Off The Tv Monitor Together With The Communication Terminal - Sony PCS-G50 System Integration Manual

1-4-2. Turning On/Off the TV Monitor Together with the Communication
Terminal
If a Sony TV monitor is used, insert the IR repeater under the remote sensor of the TV monitor. Once the
IR repeater is set, the TV monitor will turn on or go to standby together with the communication terminal
by pressing the / button on the supplied remote commander.
MCU VIDEO OUT
1 2 3
DC 19.5V
IR OUT
AUX CONTROL
1 2
to IR OUT
Using a remote control receiver
The remote control receiver of this unit is located at the bottom of a camera unit (PCS-CG70/CG70P).
However, a remote control receiver can be installed in the optimum place using a supplied remote control unit.
Use a remote control unit in the following cases.
. When it is difficult to perform operation with the camera unit and monitor television kept apart and
. When an obstacle exists around a camera unit and a remote control signal cannot be sent
m
. The control receiver of a camera unit does not operate when a remote control unit is connected.
. Install a remote control unit so that mark R is put in the front position (control receiver surface).
. Attach a supplied film to the control receiver surface for improvement when it is difficult to receive a
remote control signal because of the influence of an inverter fluorescent lamp. (In this case, be sure to
install a remote control unit in the vertical direction.)
TERMINAL
AUDIO OUT AUDIO IN
(MIXED) AUX LINE
1 2
EC-MIC
TROL
CTRL-S 1
AUX MONITOR
VIDEO OUT
To CTRL-S
1-10
TERMINAL VISCA OUT
AUDIO OUT AUDIO IN MAIN
(MIXED) AUX LINE CAMERA
MIC
(PLUG IN POWER)
1 2
4 5
WHITE 1
1 2
BOARD
EC-MIC RGB OUT
CTRL-S 1 2
AUX MONITOR
VIDEO OUT
VISCA OUT
VIDEO IN
MIC CAMERA AUX IN
(PLUG IN POWER)
1 2
WHITE 100BASE-TX/
RGB OUT BOARD 10BASE-T DSB
2 ISDN UNIT
Remote sensor
IR repeater (supplied)
Remote sensor
PCS-G70/G70P/G50/G50P