Sony PCS-G50 System Integration Manual page 19

Standby Mode Function
To save power, the communication terminal will enter
standby mode if it is not operated for a specified period of
time.
When the communication terminal is in standby mode, the
POWER indicator lights in orange.
Once the communication terminal receives a call, the
standby mode is automatically released.
To release the standby mode
Press the / button on the remote commander.
To specify the standby time
Specify the time that you want the system to remain on
before entering the standby mode (1 to 99 minutes) using
"Standby Time" in the General Setup menu. To make the
system not enter the standby mode, set "Standby Mode" in
the General Setup menu to "Off".
m
. The POWER indicator on the camera goes off when the
system enters standby mode.
. If the IR repeater is installed under the remote sensor of
a SONY TV monitor, the TV monitor will enter standby
mode together with the communication terminal.
PCS-G70/G70P/G50/G50P
Setting the Video Communication System to
Standby Mode
The video communication system can be turned on with
the / button on the remote commander when it is in
standby mode.
1. Display the launcher menu on the monitor screen, then
press the / button on the remote commander.
The message "Power off?" appears on the monitor
screen.
2. Select "OK" with the
commander, then press the PUSH ENTER button.
Alternatively, press the /
commander.
button
buttons and PUSH ENTER button
The video communication system enters standby mode
and the POWER indicator on the communication
terminal lights in orange. The POWER indicator on
the camera unit goes out.
If the IR repeater is installed under the remote sensor
of a Sony TV monitor, the TV monitor will go into
standby together with the video communication
system.
To cancel setting the system to standby
Select "Cancel" with the
commander, then press the PUSH ENTER button in step 2
above.
Turning Off
1. Open the front panel of the communication terminal,
and then slide the power switch on the right to the off
position ( ).
2. Turn off the power of other equipment used for the
videoconference.
or button on the remote
button on the remote
POWER indicator
(Not lit.)
POWER indicator
(Lights orange.)
or button on the remote
1-15