Sony PCS-G50 System Integration Manual page 23

(PCS-G70/G70P)
Menu Page Item
Communication 3/5 Far End Camera Control
Setup
T.120 Data
H.239 Presentation
H.239 Live
4/5 H.239 Ratio
*3
5/5 Multipoint Mode
Broadcast Mode
Split
Sender Screen
Submonitor Output
Status
Audio Setup 1/2 Input Select
Mic Select
CTE
Echo Canceller
Lip Sync
Recording Mute
*3: Setting is added when H.320 or H.323 MCU Software is installed.
PCS-G70/G70P/G50/G50P
Description
Select "On" when controlling camera on the remote party.
Select "Off" when not controlling it.
Select "On" when having data conference conforming to
T.120 using NetMeeting. Select "Off" when not having it.
Select "On" when using presentation function conforming
to H.239. Select "Off" when not using it.
Select "On" when using dual-video function conforming
to H.239. Select "Off" when not using it.
In the bandwidth that is shared by the camera images and
H.239 presentation data, select the ratio of the bandwidth
to be used for H.239 presentation data transmission from
1/3, 1/2 or 2/3.
Select "On" when having multipoint videoconference. Select
"Auto" when switching automatically.
Select "Split" when displaying video of all connected
terminals on the split window. Select "Voice Activate" when
switching video to be distributed by audio detection.
Select "Automatic" to switch between 4-split window (for 1
to 3 terminals) and 6-split window (for 4 to 6 terminals), or
"Six-screen Mosaic" to always display 6-split window.
Select monitor video displayed on sending terminals during
multipoint videoconference.
Allows you to select the video to be displayed on the
submonitor from "Local picture" or "Speaker picture"
during a multipoint videoconference with multiple monitors
connected.
Display current communication status. ISDN line status,
LAN line status, and LAN communication status are also
displayed according to the line interface used.
Select the audio input (MIC, AUX, or MIC + AUX).
Select microphone to be used (MIC, DSB MIC, LINE or
EC-MIC).
Select whether to use the communication transducer
CTE-600 and select input connector to be connected.
Select "Off" when not using CTE-600. Select "LINE" when
inputting to LINE connector of the communication terminal,
and select "DSB AUX IN" when inputting to AUX IN
connector of the data solution box.
n
When CTE-600 is set to be used, "Input Select", "Mic
Select", and "Echo Canceller" are automatically determined
and cannot be changed.
Select "On" when using an echo canceller. Select "Off" when
not using it.
Select "On" when using a lip sync function that synchronizes
the lip motion and voice of a speaker. Select "Off" when not
using it.
Select "On" when outputting audio signal to AUDIO OUT
(MIXED) connector. Select "Off" when not outputting it.
Default
On
Off
On
On
2/3
Auto
Split
Automatic
Full Screen
Local picture
MIC
MIC
Off
On
Off
On
(Continued)
1-19